24/7 Emergency Service available

901-837-7960

24 POINT CHECKLIST

  1. Clean Burner Assembly to improve combustion, reducing waste heat
  2. Tune Burners for more efficient burns, saving energy
  3. Clean Ignition Assembly to ensure reliable operation on demand
  4. Clean & Inspect Furnace Heat Section to ensure safe operation and the absence of cracks from metal fatigue
  5. Verify Flue Draft to ensure dangerous gas by-products are properly venting to the outdoors and flue pipes are free from obstruction
  6. Inspect Flue Pipe to ensure no corrosion is present which can lead to cracks and the introduction of dangerous fumes into your home
  7. Calibrate Thermostat for accurate control and to prevent system from running longer than necessary, increasing utility usage
  8. Test Refrigerant Charge to ensure optimum levels leadingt to lower utility usage and extend compressor life
  9. Test Capacitors to ensure reliable operation and continued compressor and motor protection
  10. Test Crankcase Heaters to ensure proper compressor protection
  11. Inspect & Test Controls & Safeties to keep operating costs low and prevent failures
  12. Adjust Fan Switch to prevent wasted energy and excess sound levels from nuisance cycling
  1. Adjust Balancing Dampers to improve comfort
  2. Clean or Replace Filters to reduce energy use, reduce compressor strain, improve indoor air quality, and improve comfort
  3. Check & Adjust Blower Assembly to extend motor life, improve air quality, and reduce sound
  4. Check Air Flow to ensure proper air flow across the coil for proper humidity removal and reliable operation
  5. Visually Inspect Ductwork to identify obvious leaks, which reduce system efficiency and increase utility expense
  6. Tighten Electrical Connections to ensure uninterrupted system operation
  7. Measure & Record Voltage & Amperage to identify baseline operating conditions
  8. Lubricate All Moving Parts to maintain efficiency and extend equipment life
  9. Inspect Evaporator Coil to ensure heat transfer efficiency, reduce utility cost, and improve air quality
  10. Clean Outside Condensing Coil to restore heat transfer efficiency and reduce utility cost
  11. Clean Condensate Drains to prevent water damage and the potential for mold formation
  12. Apply Protective Coating if needed to outside unit to protect finish
Testimonials
See what customer are Saying
  • Repair or Service a Central Air Conditioning System

    Jimmy took my initial phone call and was here on the dot the next day. Took time to explain my options. Thorough and honest. I’ve already recommend Infinity to my neighbors.

    -Pam J. in Cordova, TN
  • Repair or Service a Central Air Conditioning System

    Very honest!

    -Venita M. in Memphis, TN
  • Repair Natural Gas or Propane Furnace / Forced Air Heating System

    Great experience working with this company. They were on time, did what they said they would do (and a little more) and charged the agreed amount. I even left Allen and his coworker in my…

    -Eddie H. in Memphis, TN
  • Install a Central Air Conditioning System

    They were able to install two days after coming over to give a quote for the job. The work was finished within their time estimate and they were less expensive than the other quotes I…

    -Jonathan M. in Collierville, TN
  • Install or Replace a Water Heater

    They replaced our water heater in a very timely manner and did an excellent job. I would hire them again.

    -Homeowner in Bartlett, TN
  • Install a Central Air Conditioning System

    The temperature was 95* in my house. They quickly gave an estimate to install a new air conditioner. I asked "could you do it today?" And of course they said they would. By 2:30 I…

    -Jane H. in Memphis, TN
Read More Testimonials